Magnetic Energy Automaton Mechanical Oscillator for Valence Electrons Harvesting (MEAMO-VEH) is the result of the search for a second (solar is the first) non-ionized, non-polluting (while producing power) and renewable power source that can be used portably or stationary on earth or in outer space. MEAMO-VEH is the first portable or stationary non-ionized, non-polluting (while producing power) and renewable power source that can be used under the oceans and/or in total darkness, even able to be used in remote ionizing nuclear decay environments. MEAMO-VEH is a linear mechanical oscillator that can be used for pumping action or converting linear motion into angular motion like a mechanical watch motion (https://www.youtube.com/watch?v=G1XBb7kJJWg) without the constant external winding of spring tension.
Continuous linear mechanical oscillator with only permanent magnets was started by Professor Eric Laithwaite (https://www.youtube.com/watch?v=0tJfqMYHaQw&t=4s;Timestamp 4:20) and now finished by Greg Spaulding. From Professor Laithwaite lecture "The Circle of Magnetism" cylinder-shaped permanent magnetics same polarity ends are attraction coupled together with a 304 Ferritic piece of steel of sufficient diameter and thickness, and then the coupling is severed by the insertion of another 304 Ferritic piece of steel of the same sufficient diameter and thickness, which causes ferromagnetic repulsion. I discovered from experimentation pyrolytic carbon of the same sufficient diameter and thickness as the piece of 304 Ferritic of steel but with a hollowed center pushed onto the 304 Ferritic piece of steel causes diamagnetic repulsion. From the lecture in a same polarity magnetic flux coupler for linear cylinder permanent magnets all four end polarities must integrate their flux flow into the 304 Ferritic piece of steel or the close meeting ends of same magnetic flux polarity causes ferromagnetic repulsion. The permanent magnetic cylinders with holes drilled down the center and its holes filled on both ends with polished tempered aluminum glass grommets allow minimal friction oscillation from and to 304 Ferritic steel couplers on polished 200 Austenitic steel poles. To make the oscillations autonomous the pyrolytic carbon circular pieces are attached to a balanced carriage, so when one side of a mating magnetic cylinder coupler is covered by the oscillating magnetic cylinder pull strength pushed on pyrolytic carbon the other is uncovered and ready for attracting the magnetic cylinder back to itself.