My proposal is to use the motorcycle stator based design around the axle of a vehile (used in hybrid or electric vehile were a gas powered engine is not used with alternator). This should allow some electricity to be generated while the vehicle is in motion, this would also open up many new parts and jobs.

The stator is the stationary part of a rotor system, found in an electric generator or electric motor

Depending on the configuration of a spinning electromotive device the stator may act as the armature, receiving its influence from moving field coils on the rotor. Placing the field coils in a worm gear pattern on the rotor allows for an inexpensive slip ring mechanism to transfer high-voltage, low current power to the rotating field coil.

The housing consists of a steel frame enclosing the rotor/axle and will carry the electrical wires back to the battery. The axle sections can be bolted together by the housing.