My idea behind Self Conductive Cell is to provide endless power source to any electronic system where it is suitable to use. In this cell three components are there. Those are diodes, Silicon and Aluminum Mixture block and Silicon and Phosphorus mixture block. These blocks are separated by PN junction diodes. All the diodes, Silicon-Aluminum and Silicon-Phosphorus blocks are placed in the cell according to the figure.

Movement of electrons inside the cell as follows

1) Free electrons available in the Silicon-Phosphorus block is more than Silicon-Aluminum Mixture block which is placed in the bottom of the cell. So PN junction diode placed in between them will be forward biased (Diode will be placed accordingly).

2) The diode placed in between Silicon-Aluminum mixture block of the cell which is placed at the bottom of the cell and outer connecting wire such that holes of the Silicon-Aluminum block emit electrons to the outer connecting wire due to forward bias of the concerned diode.

3) The diode placed in between Silicon-Aluminum mixture block of the cell which is placed at the top of the cell and outer connecting wire such that holes of the Silicon-Aluminum block absorb electrons from the outer connecting wire due to forward bias of the concerned diode.

4) The diode placed in between Silicon-Aluminum mixture block of the cell which is placed at the top of the cell and the Silicon-Phosphorus block then will be forward biased due to lack of electrons in the Silicon-Phosphorus block because it released free electrons which were absorbed by the bottom Silicon-Aluminum block at the previous cycle of this phenomenon.

5) The diode placed in between Silicon-Aluminum mixture block of the cell which is placed at the bottom of the cell and the Silicon-Phosphorus block then will be forward biased due to lack of electrons in the bottom Silicon-Aluminum block because it released electrons which were absorbed by the top Silicon-Aluminum block through external conducting wire.

These five steps will be behaved like steps of a cycle accordingly and we able to gain power.

N.B: In case of diodes no conducting wire can be used inside the cell because it will provide lots of free electrons to the cell that can down the cell.