Exciter

Votes: 0
Views: 1857

Exciter

The "Exciter" is an unlimited high density power source, ( not a power converter )... for application where electrical energy is required. The design may be used for home heating , water purification , electricity production also to motivate an electric automobile that will provide unlimited range and "on demand" service.. ( no battery charging ...no additional infrastructure to build.. no automotive "down time" required to then charge a battery.

Please note this design does not require constant pneumatic pressure displacement to operate... only then at " start up "... ( also an additional pulley and mechanical air compressor with electric clutch , [ automatically engaged referencing the sensor number 31 ], may be added then driven by the drive belt assembly then feeding air pressure to number 34 with a one way valve upon the connecting flow tube ). The mechanical air compressor will have filtered air intake.

Parts list

1. Small pulley
2. Tension pulley / adjust by screw and retention spring to then allow for slight play in the belt tension
3. drive belt
4. large pulley
5. generator with magneto
6. electric motor
7. 1:20 ratio gear set high side toward number 8( optional hydraulic impeller tandem rotating with the high side of the ratio gear set
8. hydraulic pump
9. hydraulic impeller
10. R.P.M. sensor (revolutions per minute)
11. flow restriction valve ( controlled by systems logic circuits
12. voltage regulator
13. voltage regulator
14. Valve control system ( positional solenoid with safety system to full flow restriction position
15. System mapping logic circuits "control "system contains Dc ( direct current ) to Ac ( alternating current ) electricity power inverter
16. Air exhaust filter box and filter
17. pneumatic flow tube
18. permanent magnet dynamo
19. pneumatic impeller
20. Pneumatic "Start" valve controlled by manual actuation
21. Air pressure
22. Silicone oil under air pressure
23. max pressure safety valve vents to the exterior of the system
24. one way flow valve
25. oil flow tube / pipe and or flex tube "rubber" at correct pressure rating
26. High tension wire "bus" connector
27. Electric motor ( for multi function rotational torque ) system out put at rotary motion unlimited
28. circuit controlled variable resistor
29. Multi "wire" "bus" clip instrumentation "display" connector ( "ribbon" wire)
30. Manual "throttle" potentiometer / variable resistor
31. Pneumatic pressure sensor
32. electric air compressor with one way fill valve then by manual bicycle air pump then under the driver seats cushion retractable and hidden pump hinged right front corner of the seat........
33. air compressor filter and air "intake"
34. Combined component pressure tank ( air pressure and silicone oil / oil non conductive and non flammable )

Video

Voting

Voting is closed!

  • ABOUT THE ENTRANT

  • Name:
    Eric Crews
  • Type of entry:
    individual
  • Profession:
    Engineer/Designer
  • Number of times previously entering contest:
    4
  • Eric's favorite design and analysis tools:
    I LIKE AUTO CAD AND MY DRAFTING BOARD
  • Eric's hobbies and activities:
    MACHINE DESIGN
  • Eric belongs to these online communities:
    FACEBOOK
  • Eric is inspired by:
    SEEING THE CONDITIONS IN CURRENT SITUATIONS REGARDING THE FAILURES OF UTILITY COMPANIES TO MAINTAIN A COST EFFECTIVE SOURCE OF POWER FOR PEOPLE. THE INCLEMENT WEATHER CAUSING POWER OUTAGES ENDANGERS PEOPLE SO WE HAVE ADDRESSED THIS PRODUCING DESIGNS THAT REQUIRE NO FUEL OR ENVIRONMENTAL ENERGY INPUT. IE SOLAR POWER/ HYDRO ETC.
  • Patent status:
    none