2023
Entries
In the aviation industry, sealant removal is among the most terrible work for maintenance people, especially when removing sealant inside fuel tanks. Present tooling is mostly either heavy in weight or big in size and not effective. Therefore, our tooling can erase the above issues.
The Dual High Efficient Generator has numerous applications from which it can produce electric power and benefits over a traditional generator design. Here’s some examples:
By having an inner & outer Generator, the loads are equally balanced by the two generators, thus minimizing the resistance on the coils & lower RPM &
Existing three-dimensional (3D) printing technologies, whether polymer-based or metal-based, can only produce only-plastic structures or only-metal structures, which severely limits the application of additive manufacturing technologies (AM) in electronics such as IOT, ICT, and robotics. Electronic devices typically consist of both functional plastics and metals, including sensors and microactuators.
The 4450 lb weight BLU-122 deep penetrating bomb was developed by the U.S. Air Force in 2003 making improvements upon the BLU-113 penetrator which would enable it to have significant penetration through hard targets. The weapon incorporates ~ 780 lb of energetic explosive filling,
ATOMIQ is developing a new propulsion system based on zero emissions using advances in general relativity and quantum mechanics. ATOMIQ was created with a sustainable energy primary focus to offset the needs for fossil fuel since it replaces vehicle technologies that still run on combustion with alternatives that run on magnetohydrodynamics.
A Non-Metallic Far-Infrared (FIR) and IR (infrared) Thermoplastic (eg PTFE) DX Fluid Heater/Boiler and Heat Exchanger and Method is disclosed. No direct contact of heat source (electric IR emitters) with heated fluid media; no heating of IR-transparent (low reflectivity) exchanger surfaces in contact with fluids;
Non contacting opposable magnets allow for a non contact surface. This also allows for a return to a spring action in the joint.
Laminated electrical steel core is an indispensable component of electric motors. It is required that the magnetic properties of the lamination core be optimum in all the directions of the sheet plane so that maximum efficiency and minimum energy losses can be achieved.
Although modern medical treatment can cure patients with head and neck cancer, the muscle fibrosis caused by the treatments can lead to a progressive inability to open their mouths, forming trismus. Jaw-opening exercises have been proven to effectively optimize the condition. However,
Since the introduction of water cooling to offroad performance motorcycles in 1981 [1], the most integral part of engine thermal management has remained unchanged. The traditional design of radiators uses winding louvers to exchange heat with the surrounding air in repeated zigzagging patterns (shown in Figure 1).
Page 24 of 41